"Template" Quotes from Famous Books
 ... the work had been done that there had been little inaccuracies in driving the gauge spike, to which the rail was thrown, probably from various causes. The rail to be moved may not always have been exactly in its proper place, and then the template in the hurry may not have been accurately placed, or the spike may have ...
— Scientific American Supplement, No. 623, December 10, 1887 • Various
... in. in length. The current is collected by four brushes. The fitting and mechanical build of the dynamos leaves nothing to be desired. All the working parts of the dynamos and engines are turned up to gauge and template, so as to be interchangeable. As an instance of this, the armature of the generator was built in the works, while the field magnets were being erected in the exhibition, and, on arrival, fitted in position perfectly, and ran ...
— Scientific American Supplement, No. 711, August 17, 1889 • Various
... seams are properly proportioned butt and strap or lap riveted joints dependent upon the pressure for which the boilers are built. Where butt strap joints are used the straps are bent to the proper radius in an hydraulic press. The courses are built independently to template and are assembled by an hydraulic forcing press. All riveted holes are punched one-quarter inch smaller than the size of rivets as driven and are reamed to full size after the plates are assembled. All rivets are ...
— Steam, Its Generation and Use • Babcock & Wilcox Co.
... guv'nor"—thus ran his Jeremiad—"in dealin' with these here irregular settin's out, where nothin's not to say parallel with anything else, nor dimensions lendin' theirselves to accommodation. 'Just you let me orfer it in,' I says 'afore the final stitchin' to, or even a paper template in extra cases is a savin' in the end.' Because it stands to reason there goes more expense with an ill-cut squint or obtoose angle, involvin' work to rectify, than cut ackerate in the first go-off. Not but what ruckles may disappear under the tread, only there's ...
— Somehow Good • William de Morgan
... of being nearly straight, the nut should be made to follow the course of the purfling, this will require some care in the cutting and finishing of it. For this a piece of almost any veneer cut to the exact flow or drawing of the line may be used as a guide or template. The block from which the nut is to be made having been cut quite level, the line can be traced with a fine pointed pencil, or better, a fine pointed knife, and then shaped with a sharp chisel. The block or ...
— The Repairing & Restoration of Violins - 'The Strad' Library, No. XII. • Horace Petherick |
